Ideal
The Ideal Logic Air is a monobloc air-source heat pump featuring 28mm hydraulic connections and compatibility with Halo Air controls and pre-plumbed cylinders.
The Ideal Logic Air Monobloc Heat Pump System represents the latest generation of air-to-water heating technology from Ideal Heating. Designed for UK domestic installations, this monobloc unit integrates with the Halo Air Interface and ZT zone thermostats. This technical overview, based on manufacturer schematics, details the hydraulic requirements, including 28mm pipe connections and mandatory volumiser configurations. It serves as a reference for heating engineers planning system layouts and cylinder integrations for the Logic Air range.
Stick a QR tag on the case, scan it on every service and give your customer a permanent, shareable service history they can pull up from any phone.
Permanent, shareable service history
One QR scan on the boiler surfaces every previous fault, part change and visit — no paperwork to dig out.
Free AI fault diagnostics, built in
Every tag you fit unlocks the AI diagnostic tool for that exact model — paste a fault code, get a ranked cause list.
Your name on the boiler forever
When the next service or breakdown comes around the homeowner scans and sees your number first.
First 12 BoilerTags are free
Tag every install and service you do from now on — the subscription only kicks in once you scale past your first dozen.
Diagnosing a fault on a Ideal Logic Air Monobloc Heat Pump System right now?
Try the free AI fault diagnostics tool — no signup needed.
Full technical specifications extracted from the manufacturer brochure. Empty sections are hidden.
The Ideal Logic Air Monobloc Heat Pump System is a 2026-introduced air-source unit designed to streamline domestic decarbonisation. As a monobloc system, the refrigerant cycle is entirely contained within the outdoor unit, simplifying the installation process by removing the need for F-Gas qualifications for the hydraulic connection. According to the manufacturer's schematics, the system utilizes 28mm pipe sizes for the primary flow and return, ensuring sufficient flow rates for efficient heat transfer across the heat pump's operating range.
System design for the Logic Air requires careful attention to hydraulic volume. The schematics indicate that a volumiser is required to maintain the minimum water content necessary for defrost cycles and stable operation. This is particularly critical in systems with low-volume emitters or where zone valves may restrict flow. The unit is compatible with various storage solutions, including the Single Zone Pre-Plumbed Cylinder, the Two Zone Pre-Plumbed Cylinder, and standard non-pre-plumbed heat pump cylinders. These options allow for flexible installation in both new-build and retrofit scenarios.
Control integration is managed through the Halo Air Interface, which provides the primary communication link between the heat pump and the internal heating system. For multi-zone configurations, the Logic Air supports the ZT1 and ZT2 Zone Thermostats, allowing for precise temperature management across different areas of the property. While specific refrigerant data and sound power levels are not detailed in the schematics guide, the 2026 model year designation suggests compliance with the latest UK energy efficiency and environmental standards.
Installers should note that while this document focuses on schematics, the physical installation must account for the specific clearances required for the monobloc unit to ensure adequate airflow. The use of 28mm pipework is a standard requirement for these units to minimize pressure drop and maintain the flow rates required for the heat pump to operate at its peak seasonal coefficient of performance. For engineers transitioning from gas boiler installations, the Logic Air provides a familiar logic in its control interface, though the hydraulic requirements—specifically the volumiser and pipe sizing—differ significantly from traditional high-temperature systems.
Common questions from engineers and homeowners about the Ideal Logic Air Monobloc Heat Pump System.
We hold the Ideal Logic Air Monobloc Heat Pump System manual — and every other UK boiler and heat pump brochure. Sign up and pull any model up from your phone, on the job.
Sign up to access brochuresTag it before you leave. Next scan shows every service, fault and part change — and the AI diagnostic tool is free on every tag you fit.
Specifications on this page are extracted from the manufacturer brochure. Always cross-check against the latest datasheet before commissioning or quoting. Last updated 30 April 2026.